Snapper HWPS26600RV Manuale Utente

 

 

4.3.3.  DRIVEN DISC ADJUSTMENT 
The driven disc position is set at the factory and 
should not require adjustment. The proper 
adjustment is displayed in Figure 4.5. If adjustment 
is required proceed as follows. 
1.  Loosen jam nut from ball joint on transfer rod. 

 
 
 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

2.  Remove transfer rod retaining clip. See Figure 4.6. 

 
 
 

 

3.  Remove driven disc spring. 
4.  Place ground speed control in the 1st speed  
position. 
5.  The thrust plate and deck bracket should touch in 1

st

 

gear. 
6.  Adjust transfer rod by rotating clockwise or counter-
clockwise as needed until it will just slide into hole on 
ground speed control rod. 
7.  Attach transfer rod to speed control rod and install 
retaining clip. 
8.  Tighten jam nut on transfer rod ball joint. 
9.  Attach spring to thrust plate.