Snapper HWPS26600RV Manuale Utente

 

 

4.3.4.  Replacing Driven Disc Rubber Ring 
If the rubber ring is badly chunked or worn down to 
within 1/16” of the metal rim of the driven disc hub, 
it must be replaced.  
1.  Remove the clip from the transfer rod. Then 
remove the transfer rod from the clip and the speed 
control rod and swing rod towards driven ring. See 
Figure 4.7. 

 
 

 

 
2.  Remove belt guide for the engine to deck belt. 
3. Unhook the driven disc spring and slide the 
driven disc assembly off the hex shaft. See Figure 4.7. 
4.  Remove the five machine screws and plate that 
secures the rubber ring to the driven disc hub.  See 
Figure 4.8. 
5.  Install new rubber ring. 
6.  Reverse above procedures for reassembly and 
installation. 
NOTE: When reinstalling belt guide, position the guide 
1/8” from belt with belt in the engaged position. 

 

4.3.5.  Replacing Bearing In Driven Disc 
If the driven disc bearing fails, remove the driven 
disc assembly and replace bearing as follows: 
1.  Remove snap ring. 
2.  Slide the hub assembly out of the bearing. 
3.  Remove the four screws. 
4.  Remove bearing and replace with new bearing. 
5.  Reassemble components in reverse order.