Roland AT20s Manuale Utente
16
Before You Start Playing
Opening/Closing the Lid
fig.01-02
1.
To open the lid, hold it with both hands and
slide it to the rear.
2.
To close the lid, slowly pull it forward until it
stops.
* Be careful not to get your fingers caught when opening or
closing the lid. Adult supervision is recommended when small
children are going to be using the instrument.
* To prevent accidents, be sure to close the lid before moving the
organ.
* Make sure you don’t have anything (such as sheet music) on the
keyboard when you close the lid.
Setting Up the Music Stand
fig.01-03
1.
Attach the music stand by inserting it into the
two holes.
Connecting the Power Cord
1.
First, make sure that the [Power On] switch at
the panel’s left side is OFF (not pushed in).
2.
Connect the supplied power cord to the AC Inlet
connector, then plug the other end into an AC
outlet.
fig.01-04
* Only use the power cord supplied with this instrument.
* Whenever you do not intend to use the instrument for extended
periods of time, pull out the power cord from the AC outlet.
Turning the Power On and Off
* Once the connections have been completed, turn on or off power
to your various devices in the order specified. By turning on or
off devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
■
Tuning On the Power
1.
Make sure of the following before the power is
turned on.
• Is the power cable correctly connected to the AC inlet?
• Is the power cable correctly connected to the AC outlet?
• Is the [Master Volume] knob (located at the left of the
Lower keyboard) set to the Min (minimum) position?
fig.01-05
2.
Press the [Power On] switch to turn on the
power.
fig.01-06
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
3.
The [Master Volume] knob is an overall control
for adjusting the volume of the entire instru-
ment.
Position the Expression Pedal to the half-way mark. Now
adjust the [Master Volume] knob to a suitable level. Now
that this level has been set, you can use the Expression
Pedal to change the volume with your foot as you play the
AT-20S. The volume will be increased when the Expres-
sion Pedal is pressed down, and decreased when the ped-
al is returned.
adjust the [Master Volume] knob to a suitable level. Now
that this level has been set, you can use the Expression
Pedal to change the volume with your foot as you play the
AT-20S. The volume will be increased when the Expres-
sion Pedal is pressed down, and decreased when the ped-
al is returned.
fig.01-07
Max
Min
Master
Volume
Power On
ON
Lower position
increase
the volume
the volume
decrease
the volume
the volume
Max
Min
Master
Volume
AT-20S.e.book 16 ページ ２００３年１１月１０日 月曜日 午後２時３７分