Roland VR-700 Manuale Utente

 

Connecting MIDI Equipment

 

fig.ConnectPC.eps

 

You can use a USB cable (sold separately) to connect the VR-700 to 

your computer.

If the VR-700 is connected to a computer in which sequencer 

software is installed, the playback from the software can be 

sounded by the VR-700, and your performance on the VR-700 can 

be recorded by your software.

If you are using sequencer software on your computer, and your 

sequencer software’s MIDI Thru function is enabled, change the 

following Function mode parameters as follows.

• Set “Local Control” to OFF (it will be ON when the power is turned 

on)

• Set “USB MIDI Thru Switch” to ON (factory setting is OFF)

* If your sequencer software’s MIDI Thru function is not enabled, 

there’s no need to change these settings.

* The “Local Control” setting is not remembered by the VR-700. It will 

be ON when you turn on the power.

* If “Sub Keyboard Function” (p. 57) is set to Upper (or Lower), MIDI 

messages received at the MIDI IN connector will automatically be 

converted to the MIDI channel specified by “Upper Organ MIDI 

Channel” (or “Lower Organ MIDI Channel”). The routing will be the 

 

fig.MIDIroute02.eps

 

Connecting your Computer

 

Local Control Setting

VR-700_e.book 67 ページ ２００９年１１月１８日　水曜日　午前９時２４分