Sony SRP-V110 Manuale Utente
11
INSERT
MONO INPUT
5
LINE
MIC
INSERT
6
LINE
MIC
INSERT
3
LINE
MIC
INSERT
4
LINE
MIC
INSERT
1
LINE
MIC
INSERT
2
LINE
MIC
1
2
3
4
5
6
2
MONO INPUT
1
INSERT
9
LINE
MIC
INSERT
7
LINE
MIC
TAPE
IN
1
4
7
3 2
GRP/
DIRECT
OUT
Name and function of
each part
!¡
8 AUX OUTPUT connectors
Phone jacks (Unbalanced, reference level: +4 dBu)
9 2TR OUT connectors
Phono jacks (Unbalanced, reference level: –10 dBu)
These distribute and output the MASTER OUTPUT L/
R signals. They are connected to DAT or MD recorders,
or equivalent.
These distribute and output the MASTER OUTPUT L/
R signals. They are connected to DAT or MD recorders,
or equivalent.
!º MONITOR OUT connectors
Phone jacks (Unbalanced, reference level: +4 dBu)
These output the same signals as the PHONES
connector, and signals from any channels whose PFL
or AFL buttons are turned on can be confirmed.
These output the same signals as the PHONES
connector, and signals from any channels whose PFL
or AFL buttons are turned on can be confirmed.
!¡ MASTER OUTPUT connectors
XLR-3-32 type
(Balanced, reference level: +4 dBu)
(Pin No. 1: ground, No. 2: hot, No. 3: cold)
(Balanced, reference level: +4 dBu)
(Pin No. 1: ground, No. 2: hot, No. 3: cold)
!™ MASTER INSERT connectors
Phone jacks
(Unbalanced, reference level: –6 dBu)
(Tip: output, Ring: input, Sleeve: ground)
These are the INSERT IN/OUT connectors of the
MASTER OUTPUT. External equipment can be
inserted before the L/R fader. They are connected to
the compressor or gate, etc.
(Unbalanced, reference level: –6 dBu)
(Tip: output, Ring: input, Sleeve: ground)
These are the INSERT IN/OUT connectors of the
MASTER OUTPUT. External equipment can be
inserted before the L/R fader. They are connected to
the compressor or gate, etc.
!£ +48 V button
This is the button to supply power (DC +48 V) for
condenser microphones to the MIC connectors of the
MONO INPUT channels 1 - 8. When this button is
turned on, DC +48 V is output to all MIC connectors.
condenser microphones to the MIC connectors of the
MONO INPUT channels 1 - 8. When this button is
turned on, DC +48 V is output to all MIC connectors.
Caution
• Before turning on the +48 V button or after changing the cable
connection, turn down the output fader or the output volume.
• The line equipment must be connected to the LINE input side.
• When a dynamic microphone is used in conjunction with a
• When a dynamic microphone is used in conjunction with a
microphone that uses +48 V power, the dynamic microphone
may under-perform.
may under-perform.
*
0 dBu=0.775 V