Roland VH-11 Manuale Utente

Connecting and Adjusting

921

* To prevent malfunction and/or damage to speakers or other

devices, always turn down the volume, and turn off the power
on all devices before making any connections.

Connect the VH-11’s TRIGGER OUT jack to the

sound module’s TRIGGER INPUT HI-HAT jack,

and the VH-11’s CONTROL OUT jack to the

sound module’s HH CTRL jack.

fig.Connect.e

* Use stereo (TRS) cables to make the connections. If monaural

cables are used, edge shots cannot be supported.

Secure the cables in place with the cable tie,

while leaving some slack in the cables.

fig.CableTie.e

The VH-11’s offset needs to be adjusted to ensure proper
expression of the hi-hat’s opening and closing. Perform this
adjustment while the sound module is connected.

This section describes the adjustment procedure when the
VH-11 is used with a TD-12.

Refer to p. 8 if you are using a different sound module.

Confirm that the VH-11 and TD-12 are

connected properly.

After making the hi-hat settings, release your

foot from the pedal, and while keeping your foot

off the pedal, turn on the power to the TD-12.

* The offset cannot be adjusted correctly if the hi-hat is making

contact with the motion sensor unit when the power is turned
on.

Loosen the clutch screw and let the hi-hat rest

naturally on the motion sensor unit.

Press the TD-12’s [TRIGGER] button, then

press the [F1 (BANK)] button.

The “TRIGGER BANK” screen appears.

Press the [CURSOR] buttons to move the

cursor to the trigger type for TRIGGER INPUT 6.

Use the [+/-] buttons or the [VALUE] dial to

select “VH11.”

fig.TrigBank-12

Connecting to a Sound
Module

TRIGGER OUT

jack

to the

sound module’s

TRIGGER INPUT

HI-HAT jack

to the

sound module’s

HH CTRL jack

CONTROL OUT

jack

Tighten it
not to slip

Wind the
cable tie
once

Turn back to
fix the cables

Leave some
slack in the
cables

Adjusting the Sound Module
TD-12 and VH-11’s Offset

Using the TD-12

VH-11_e 6 ページ２００５年４月１２日　火曜日　午後１時２０分