Miranda Camera Co M406-9900-402 Manuale Utente

10  |  Kaleido K2 

The rear connector panel (11) associated with the Controller module has the following connectors: 
 
Ethernet: RJ-45 

connector 

 

Ethernet interface for connection to LAN/WAN networks using TCP-IP.  

 
RS-422/485: DE-9S 

connector 

 

For connecting the Kaleido-RCP or other remote control devices. 

 

 

 

 
 
RS-232 : DE-9P 

connector 

 

To connect to router status information sources for tracking UMDs. 

 
 
 
 
 
 
 
 

 
 
USB: 

Used to connect a USB mouse, CD-ROM or portable hard disk to upgrade or service the unit.  A 
similar USB connector may also be found on the front edge of the Controller module, accessible 
only when the front is removed. 

 
Mouse,  
Keyboard: 

The mouse and keyboard inputs allow the user to operate the Kaleido locally. 

 

 

 
LTC IN: BNC 
 

The time code input connector allows the system’s internal clock to be synchronized to the 
station’s time. 

 

LTC signal must conform to SMPTE 12M (EBU-3259-E) standard. 

 
REF IN: 

BNC 

Connect a reference input signal to genlock the Kaleido-K2 (i.e. lock the Kaleido-K2’s internal clock 
circuitry to this external reference). 

The input reference can conform to any of these standards: 

 

      SMPTE 170M, SMPTE 318M, ITU 624-2, BUT 470-6, or composite sync. 

 
 
The front card-edge of the Controller module has several controls, some accessible only when the front panel is 
removed. Figure 4.4.1.4 shows the location of the controls on the front edge of the Controller module. 
 
ON/OFF pushbutton:  turns the unit on and off (the power supplies in the rear of the unit remain ON).   
 
Power ON LED: 

this bi-color LED reports the general status of the unit and monitors the power supplies. 

  

When 

off, both power supplies are switched off  or not plugged in.