Cisco Systems 1552H Manuale Utente

To connect the backup battery cable and close the access point radio cover, follow these steps:

Carefully position the access point radio cover over the access point as shown in 

. 

Hold the radio cover upright while placing the edge of the radio cover on the top edge of the access point.

Carefully push the backup battery cable connector into the internal battery connector (see 

Close the radio cover, while being careful not to pinch the backup battery cable.

Use a Phillips screwdriver to partially tighten each cover screw in the tightening sequence, starting with 
1, as shown in 

. Tighten each screw to 11 to 12 in. lbs (1.24 to 1.36 Nm).

Repeat 

 using the same tightening sequence to fully tighten each screw to 22 to 24 in. lbs

(2.49 to 2.71 Nm).

After you have completed the backup battery procedures, your access point is ready to be deployed. 
Carefully read and follow the safety and installation guidelines contained in the 

 and the installation and mounting instructions contained in the 

255268