DCS 1.0x Manuale Utente

dCS Verona User Manual

Manual for Software Issue 1.0x

dCS Ltd

September 2004

Manual filename: Verona Manual v1.0x.doc

Page 16

email: more@dcsltd.co.uk

English version

web-site: www.dcsltd.co.uk

Bright x

- Display Brightness

This adjusts the brightness of the main display, with settings between 7
(brightest) and 0 (off, unless something is touched).

do this:

Open the Menu and step through until the display shows

Bright x

, where x is a

number between 7 and 0.

do this:

Press the

Select

button repeatedly and the display cycles through

Bright 7

Bright 6

.......

Bright 1

Bright 0

and back to

Bright 7

After time-out, a setting of

Bright 0

blanks the display unless the unit is not

locked. Operating any control or locking to a source while in this mode turns the
display back on momentarily.

TimeOut

– Menu Time Out Setting

If you find the 5 second time out period for the menu is too short, use this option
to change the time out period.

do this:

Open the Menu and step through until the display shows

Timeout

do this:

Press the

Select

button repeatedly and the display will cycle through the

options:

None, 5 secs, 15 secs, 30 secs, 1 min, 3 mins

When set to

None

, the menu does not close automatically. Close it manually by

stepping through to the

End

page and pressing

Select

do this:

Choose the setting you want and press the

Select

button again.

Test

- Display Test

This runs a test routine to ensure the display is working correctly.

do this:

Open the Menu and step through until the display shows

Test

do this:

Press the

Select

button once to start the test.

•

The main display lights up then fades from bottom to top.

•

The indicator LEDs light up briefly in sequence.

•

All indicators light up, along with small squares on the main display. This

flashes off and on once.

•

The display shows

Done

Issue

– Software Issue State

This displays the issue number of the software fitted to your unit. You will need
to check this if you are considering a software upgrade or if your unit
malfunctions.

do this:

Open the Menu and step through until the display shows

Issue

do this:

Press the

Select

button once to display the software issue.

do this:

For units fitted with a

1394

interface, press the

Select

button again to display

the 1394 interface software issue.

Temp

– Unit Internal Temperature

This displays the temperature inside the unit, close to the crystal oscillators.

do this:

Open the Menu and page through until the display shows

Temp

do this:

Press the

Select

button once to display the temperature in degrees Fahrenheit.

Press

Select

again to change to degrees Celsius.