Motorola MVME162 Manuale Utente
Hardware Preparation and Installation
2-10
MVME162 Embedded Controller Installation Guide
2
MVME162 Module Installation
With EPROM, IndustryPack, and SIMs installed and headers properly
configured, proceed as follows to install the MVME162 in the VME chassis:
configured, proceed as follows to install the MVME162 in the VME chassis:
1.
Turn all equipment power OFF and disconnect the power cable from the
AC power source.
AC power source.
C
aution
Inserting or removing modules while power is applied
could result in damage to module components.
could result in damage to module components.
!
WARNING
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, test-
ing, and adjusting.
this equipment. Use extreme caution when handling, test-
ing, and adjusting.
2.
Remove the chassis cover as instructed in the user’s manual for the
equipment.
equipment.
3.
Remove the filler panel from the card slot where you are going to install
the MVME162.
the MVME162.
–
If you intend to use the MVME162 as system controller, it must occupy
the leftmost card slot (slot 1). The system controller must be in slot 1
to correctly initiate the bus-grant daisy-chain and to ensure proper
operation of the IACK daisy-chain driver.
the leftmost card slot (slot 1). The system controller must be in slot 1
to correctly initiate the bus-grant daisy-chain and to ensure proper
operation of the IACK daisy-chain driver.
–
If you do not intend to use the MVME162 as system controller, it can
occupy any unused double-height card slot.
occupy any unused double-height card slot.
4.
Slide the MVME162 into the selected card slot. Be sure the module is
seated properly in the P1 and P2 connectors on the backplane. Do not
damage or bend connector pins.
seated properly in the P1 and P2 connectors on the backplane. Do not
damage or bend connector pins.
5.
Secure the MVME162 in the chassis with the screws provided, making
good contact with the transverse mounting rails to minimize RF
emissions.
good contact with the transverse mounting rails to minimize RF
emissions.
6.
Install the MVME712 series transition module in the front or the rear of the
VME chassis. (To install an MVME712M, which has a double-wide front
panel, you may need to shift other modules in the chassis.)
VME chassis. (To install an MVME712M, which has a double-wide front
panel, you may need to shift other modules in the chassis.)
7.
On the chassis backplane, remove the
INTERRUPT ACKNOWLEDGE
(IACK) and
BUS GRANT
(BG) jumpers from the header for the card slot
occupied by the MVME162.