NEC PD78P214 Manuale Utente
75
Chapter 5 Port Functions
5
Fig. 5-20 Connection of Pull-Up Resistors (Port 3)
5.5 PORT 4
Port 4 is an 8-bit I/O port with an output latch. The memory expansion mode register (MM) can put all 8 bits of
this port in either the input or output mode at one time. Each pin has a software-programmable built-in pull-up
resistor, and can drive an LED directly.
this port in either the input or output mode at one time. Each pin has a software-programmable built-in pull-up
resistor, and can drive an LED directly.
When an external memory or I/O device is expanded, port 4 functions as a time-division address/data bus (AD0
through AD7).
through AD7).
For the
µPD78213, port 4 functions only as a time-division address/data bus (AD0 through AD7).
When the RESET signal is input, port 4 becomes an input port (high output impedance), and the contents of the
output latch become undefined.
output latch become undefined.
Internal bus
V
DD
P30
P31
P32
P36
P37
Input buffer
PUO3
(PUO)
•••
• • •
•••
•••
Port 3 mode
register (PM3)
register (PM3)