Intel D95738-001US Manuale Utente

16 

 

The board has four DIMM sockets and support the following memory features: 
•  1.8 V (only) DDR2 SDRAM DIMMs with gold-plated contacts 
•  Unbuffered, single-sided or double-sided DIMMs with the following restriction: 

Double-sided DIMMS with x16 organization are not supported. 

•  8 GB maximum total system memory using DDR2 800 or DDR2 667 DIMMs; refer 

to Section 2.1.1 on page 39 for information on the total amount of addressable 
memory. 

•  Minimum total system memory:  512 MB 
•  Non-ECC DIMMs 
•  Serial Presence Detect 
•  DDR2 800 or DDR2 667 MHz SDRAM DIMMs 
•  DDR2 667 DIMMs with SPD timings of only 5-5-5 (tCL-tRCD-tRP) 
•  DDR2 800 DIMMs with SPD timings of only 5-5-5 or 6-6-6 (tCL-tRCD-tRP) 

To be fully compliant with all applicable DDR SDRAM memory specifications, the board 
should be populated with DIMMs that support the Serial Presence Detect (SPD) data 
structure.  This allows the BIOS to read the SPD data and program the chipset to 
accurately configure memory settings for optimum performance.  If non-SPD memory 
is installed, the BIOS will attempt to correctly configure the memory settings, but 
performance and reliability may be impacted or the DIMMs may not function under the 
determined frequency. 

DDR2 667 

512 Mbit 

256 MB 

1 GB 

4 GB 

DDR2 667 

1 Gbit 

512 MB 

2 GB 

8 GB 

DDR2 800 

512 Mbit 

256 MB 

1 GB 

4 GB 

DDR2 800 

1 Gbit 

512 MB 

2 GB 

8 GB 

 

Tested Memory  

http://support.intel.com/support/motherboards/desktop/sb/
CS-025414.htm