Emerson 752I Manuale Utente
Local PCI Bus:
Geographical Addressing
8-2
Table 8-1:
ID Select Connections
The T8110 TSI connects to INTD. The MV64460 system controller connects to INTA. The
Ethernet MAC connects to INTD. The PCI devices on the PTMC module(s) use the following
connections.
Ethernet MAC connects to INTD. The PCI devices on the PTMC module(s) use the following
connections.
Table 8-2:
Interrupt Connections for Katana
GEOGRAPHICAL ADDRESSING
The Katana
752i has three read-only registers that allow the software to read Geographical
Addresses from the CompactPCI backplane connectors. The following table describes
these registers.
these registers.
Table 8-3:
Geographical Address Registers
PCI BUS CONTROL SIGNALS
This section lists signals for the PCI interface which are available on PMC connectors J11,
J12, J21, and J22 (see also pinout tables beginning on page 9-3). Please refer to the PCI
specification for details on using these signals. All signals are bi-directional unless otherwise
stated.
J12, J21, and J22 (see also pinout tables beginning on page 9-3). Please refer to the PCI
specification for details on using these signals. All signals are bi-directional unless otherwise
stated.
Note:
A sustained three-state line is driven high for one clock cycle before float.
752i PCI Device
IDSEL Address
PTMC Site 1 (at J12)
AD20
PTMC Site 2 (at J22)
AD21
T8110 Time Slot Interchanger (TSI)
AD22
MV64460 System Controller
AD23
82544 Ethernet MAC
AD24
MV64460:
PTMC #1:
PTMC #2:
82544EI:
T8110:
INTA
INTD
INTC
–
–
INTB
INTA
INTD
–
–
INTC
INTB
INTA
–
–
INTD
INTC
INTB
INT
INT
Register
Address (Hex)
Description
J4SGA
F821,0000
Read the Shelf Enumeration Bus pins from cPCI J4 connector.
J4GA
F821,0001
Read the Geographical Address from cPCI J4 connector.
J2GA
F821,0002
Read the Geographical Address from the cPCI J2 connector.