Barco 26-0503000-00 Manuale Utente
82
MatrixPRO • 8x8 DVI Router • User’s Guide
6. Upgrading Software
Ethernet Upgrade Method
bíÜÉêåÉí=réÖê~ÇÉ=jÉíÜçÇ
Use the following steps to upgrade MatrixPRO software using an Ethernet connection
to your PC:
to your PC:
1. Ensure that your PC (or laptop) uses the Windows
®
2000 or XP operating
systems.
2. Connect MatrixPRO’s Ethernet port to a Hub or Switch.
3. Connect the Ethernet Hub or Switch to your PC. Remember that a totally “local”
network is recommended, without IP connections to the outside world.
4. Power-up MatrixPRO.
5. Make a note of MatrixPRO’s IP address — if DHCP is enabled on MatrixPRO, its
IP address may not be the default address. In Chapter 4, refer to the “
” section on page 37 for instructions.
6. On the PC, click Start > Programs > Barco Folsom > MatrixPRO DVI 8x8
Software #.## > Flash Loader to launch the Flash Loader utility.
Figure 6-3. Flash Loader Utility
7. Click Communication > Ethernet > Connect to display the Ethernet
Connection Dialog.
Figure 6-4. Ethernet Connection Dialog (sample)
Note
The default IP address is 192.168.000.243.
Note
If the Ethernet menu pick is grayed out, set the COM port to
None.
None.