Справочник Пользователя для Barco 26-0503000-00

Ethernet Upgrade Method

„

Use the following steps to upgrade MatrixPRO software using an Ethernet connection 
to your PC:

1.  Ensure that your PC (or laptop) uses the Windows

®

 2000 or XP operating 

systems.

2.  Connect MatrixPRO’s Ethernet port to a Hub or Switch.  

3.  Connect the Ethernet Hub or Switch to your PC.  Remember that a totally “local” 

network is recommended, without IP connections to the outside world.

4.  Power-up MatrixPRO.

5.  Make a note of MatrixPRO’s IP address — if DHCP is enabled on MatrixPRO, its 

IP address may not be the default address.  In Chapter 4, refer to the “

” section on page 37 for instructions. 

6.  On the PC, click Start > Programs > Barco Folsom > MatrixPRO DVI 8x8 

Software #.## > Flash Loader to launch the Flash Loader utility.

Figure 6-3.  Flash Loader Utility  

7.  Click Communication > Ethernet > Connect to display the Ethernet 

Connection Dialog.  

Figure 6-4.  Ethernet Connection Dialog  (sample)  

The default IP address is 192.168.000.243.

If the Ethernet menu pick is grayed out, set the COM port to 
None.