Nortel Networks R2MFC Manuale Utente

78 Chapter 7 Command Line Interface (CLI)

NN40010-300

CEnbl <chan> 

Performs channel enabling. 

Where:
chan is the channel number in the range of 1...15, 17...31.

This command sends a message to both protocol handlers. 

CEnblGrp <start_chan> 

<end_chan>

Performs channel enabling on a group of channels.

Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.

 LSd

Performs link soft-disabling, which disables IDLE channels immediately. 

If there is a call in progress, the system disables the channel after the 

current call is complete. This command sends a message to both protocol 

handlers. 

LId

Performs immediate link disabling. 

If there is a call in progress, the system ends the call and disables the 

channel. This command sends a message to both protocol handlers.

LEnbl

Performs link enabling. 

The command sends a message to both protocol handlers. 

CoFlm <chan>

Transfers a disabled channel to an offline state. 

Where:
chan is the channel number in the range of 1...15, 17...31.

The command sends a message to both protocol handlers. 

CoFlmGrp <start_chan> 

<end_chan>

Transfers disabled channels to an offline state. 

Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.

The command sends messages to both protocol handlers.

Table 21   CNtrl directory CLI commands (Sheet 2 of 3)