Nortel Networks R2MFC Manuale Utente

Chapter 7 Command Line Interface (CLI) 79

R2MFC Media Bay Module Installation and Configuration Guide

Table 22 includes the CLI commands for general card configuration. The commands are accessed 
from the COnfig directory. 

CoNlm <chan>

Transfers the channel to an online state. 

Where:
chan is the channel number in the range of 1...15, 17...31.

If the system accepts the message, the channel becomes disabled. This 

command sends a message to both protocol handlers.

CoNlmGrp <start_chan> 

<end_chan>

Transfers a group of channels to an online state. 

Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.

If the system accepts the messages, the channels become disabled.

MC <link_num>

Sets the side that is used as clock source.

Where:
link_num is either 0 (link 0) or 1 (link 1).

If this command is entered without a parameter, the current clock master is 

printed.

Table 22   COnfig directory CLI commands (Sheet 1 of 2)

LinePhy <phy_mode>

Sets the physical interface type of the external E1 line.

Where phy_mode can be:
0 indicating 120 Ohm (RJ48 connector).
1 indicating 75 Ohm (RX and TX, BNC connector), grounded shield.
2 indicating 75 Ohm (TX BNC connectors), not-grounded shield.

SaveCfg

Stores the current configuration on non-volatile Flash memory. 

All parameters are stored-country-specific and non-country-specific. The 

stored configuration is used when the config DIP switches on the faceplate 

are set to custom profile. Only one configuration (custom profile) is stored. 

This command deletes the previous configuration contents.

Table 21   CNtrl directory CLI commands (Sheet 3 of 3)