Nortel Networks 608(WL) Manuale Utente
Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1
141
4.7 Connection
What is ...
A Connection bundles all the parameters required for the PH2 SA negotiation:
Peer
Reference, pointing to the peer configuration to be used. In fact, this refers to
the IKE channel used for the Phase 2 negotiations.
Reference, pointing to the peer configuration to be used. In fact, this refers to
the IKE channel used for the Phase 2 negotiations.
Local/remote range
Range of private IP addresses to which the IPSec policy applies.
Reference to the Network Descriptors or expressed by a dynamic policy.
Range of private IP addresses to which the IPSec policy applies.
Reference to the Network Descriptors or expressed by a dynamic policy.
Connection Security Descriptor
Reference to the Phase 2 Security Descriptor grouping the security
parameters.
Reference to the Phase 2 Security Descriptor grouping the security
parameters.
The Connection parameters are explained in section
.
How is it used
A Connection can be successfully configured from the moment when a Connection
Security Descriptor is present in the SpeedTouch™.
Security Descriptor is present in the SpeedTouch™.
The local and remote private networks can be described either by a valid Network
Descriptor, or by a
Descriptor, or by a
keyword
present in the SpeedTouch™. When the IPSec policy is
expressed as a
static
policy, a Network Descriptor describes the local and remote
private networks. As a consequence, some valid Network Descriptors must be
defined prior to the successful definition of a Connection.
defined prior to the successful definition of a Connection.
When using a
dynamic
policy, the networks are described by
keyword
(see section
In this section
The following topics are discussed in this section:
Topic
Page