Cisco Systems Cisco 12816 Manuale Utente

The following example shows how to configure an ATM line card to use IP.

Configuring interface parameters:

Configuring interface ATM1/0:

  Is this interface in use?: yes

  Configure IP on this interface?: yes

    IP address for this interface: 1.1.1.2

    Number of bits in subnet field: 0

    Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0

After you have manually configured the network interface parameters, the RP and 
line card interfaces are available for limited use. 

To modify the currently saved configuration information, you can enter the 
setup command at the privileged EXEC mode prompt (

Milo#

) at any time to 

start another system configuration dialog session.

To perform more complex configuration tasks, you can enter the configure 
terminal command at the privileged EXEC mode prompt (

Milo#

), which 

invokes global configuration mode [

Milo(config)#

].

 

See the 

 for more information.

The show version command displays the Cisco IOS software version number as 
well as other information, including the hardware installed in the system, the 
names and sources of system image files, and the contents of the software 
configuration register.

The following example shows the type of information generated by this command.

Milo# show version

Cisco Internetwork Operating System Software 

IOS (tm) GS Software (GSR-P-M), Experimental Version 

12.0(20010120:204554) [gha]

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Sat 20-Jan-01 18:34 by ghall

Image text-base: 0x60010950, data-base: 0x61C14000

ROM: System Bootstrap, Version 11.2(17)GS2, [htseng 180] EARLY 

DEPLOYMENT RELEA)

BOOTFLASH: GS Software (GSR-BOOT-M), Version 11.2(18)GS4, EARLY 

DEPLOYMENT RELE 

Getty uptime is 22 hours, 15 minutes

System returned to ROM by reload