Cisco Systems Cisco 12816 Manuale Utente
Chapter 7 Maintaining the Router
Removing and Installing a Chassis
7-88
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Step 11
Run the show gsr command to verify that the new switch fabric cards are detected
by the system.
by the system.
Note
The show gsr command output varies slightly between each switch fabric
card set.
card set.
The switch fabric upgrade kit does not include a new label to identify the
upgraded router model, so the label on the side of the chassis still identifies the
chassis as a Cisco 12016 or Cisco 12416 router.
upgraded router model, so the label on the side of the chassis still identifies the
chassis as a Cisco 12016 or Cisco 12416 router.
You can identify an upgraded router by:
•
Reading the numbers on the switch fabric card labels.
•
Using the show gsr command to generate the switch fabric card identification
numbers.
numbers.
lists the router model and the corresponding switch fabric
card number on the identification label.
Removing and Installing a Chassis
This section provides the procedures to remove and replace a chassis. You may
need to perform this procedure to replace a defective chassis or move it to another
location. These instructions include the steps directing you to removal and
replacement instructions for individual components such as power supplies and
line cards.
need to perform this procedure to replace a defective chassis or move it to another
location. These instructions include the steps directing you to removal and
replacement instructions for individual components such as power supplies and
line cards.
Table 7-3
Identifying Switch Fabric Cards
Router Model
Switch Fabric Card Identification Label
Cisco 12016 router
SFC-80 and CSC-80
Cisco 12416 router
SFC-320 and CSC-320
Cisco 12816 router
SFC-1280 and CSC-1280