Cisco Systems Cisco 12816 Manuale Utente
Chapter 1 Product Overview
Alarm Card, Line Card, and Rout Processor Overview
1-34
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
GRP Flash Memory
Use flash memory to store multiple Cisco IOS software and microcode images
that you can use to operate the router. You can download new images to flash
memory over the network (or from a local server) to replace an existing image, or
to add it as an additional image. The router can be booted (manually or
automatically) from any of the stored images in flash memory.
that you can use to operate the router. You can download new images to flash
memory over the network (or from a local server) to replace an existing image, or
to add it as an additional image. The router can be booted (manually or
automatically) from any of the stored images in flash memory.
Flash memory also functions as a Trivial File Transfer Protocol (TFTP) server that
allows other servers to boot remotely from the stored images, or to copy them into
their own flash memory.
allows other servers to boot remotely from the stored images, or to copy them into
their own flash memory.
The system uses two types of flash memory:
•
Onboard flash memory (called bootflash) —Contains the Cisco IOS boot
image.
image.
•
20 MB Type II PCMCIA flash memory cards (MEM-GRP-FL20=)—Contain
the Cisco IOS software images.
the Cisco IOS software images.
Performance Route Processor Overview
The performance route processor (PRP) uses a Motorola PowerPC 7450 CPU that
runs at an external bus clock speed of 133 MHz and has an internal clock speed
of 667 MHz.
runs at an external bus clock speed of 133 MHz and has an internal clock speed
of 667 MHz.
identifies the slots, ports, and LEDs on the PRP front panel.
Figure 1-18 Performance Route Processor Front Panel
1
PCMCIA flash disk slots (shown with cover in
place) and slot LEDs
place) and slot LEDs
4
Console serial port
2
RJ-45 Ethernet ports and data status LEDs
5
Reset button
3
Auxiliary serial port
6
Alphanumeric message displays
EJECT
RX
TX
PRIMARY
SLO
T-
1
SLO
T-
0
LINK
EN
RX
TX
ETH 1
ETH 0
AUX
CONSOLE
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
LINK
PRIMARY
EN
RESET
129307
1
3
4
5
2
6