Nortel Networks Passport ARN Routers Manuale Utente
Using Local Boot (the Quick-Start Procedure)
114200-E Rev 00
B-3
provides the connector names and numbers you should use during the
Quick-Start procedure.
Filling Out the Worksheets
The inst_arn.bat script provides many options for configuring the ARN on a
network. Since typical remote access uses a serial interface over a wide area
connection, this sample describes only the options involved with a serial
configuration.
network. Since typical remote access uses a serial interface over a wide area
connection, this sample describes only the options involved with a serial
configuration.
We suggest the following procedure when you fill out worksheets:
1.
Fill out the Global Information Worksheet completely.
The sample worksheet lists options common to all serial interface
configurations.
configurations.
2.
After you record your protocol selections on the Global Information
Worksheet, fill out one Router Protocol worksheet.
Worksheet, fill out one Router Protocol worksheet.
Table B-1.
Quick-Start Connector Names and Numbers
Module
Interface*
* The Quick-Start script does not support initial ISDN, X.25 PAD, or V.34 interface
configuration.
Base
Expansion
Adapter 1
Adapter 2
Ethernet
XCVR1
XCVR2
N/A
N/A
Token Ring
MAU1
MAU2
N/A
N/A
Serial
N/A
COM3, COM4,
or COM5
or COM5
COM1
COM2
56/64K, FT1/T1, or
FE1/E1 DSU/CSU
FE1/E1 DSU/CSU
N/A
N/A
COM1
COM2
Note:
This section provides worksheets only for a serial interface
configuration over a wide area connection. It does not contain worksheets for
LAN configuration options. If configuring a LAN interface, read the
Quick-Start text and prompts carefully before responding, as they will differ
from the serial sample.
LAN configuration options. If configuring a LAN interface, read the
Quick-Start text and prompts carefully before responding, as they will differ
from the serial sample.