Planet Technology ADE-3410v2 Manuale Utente

“LLC/SNAP-ROUTING” as the encapsulation, and then click “Next”.

5. In the “WAN Settings” interface, input the IP address, subnet mask, and DNS server

address provided by your ISP. Don’t select “Use the following default gateway”. And
then click “Next”.

WAN IP Address: 20.1.1.2
WAN Subnet Mask: 255.255.255.0
Primary DNS server: 168.95.1.1
Secondary DNS server: 168.95.192.1

6. In the “Network Address Translation Settings” interface, enable the NAT and

firewall. And the other keep the default configuration unchanged . Then click “Next”.

7. Check the network configurations and make sure that all settings agree with the data

provided by your ISP, and then click “Save”.

8. Click “Save/Reboot” to apply the changes and reboot the system.

You can also modify the PVC 8/35. If you need to modify the LAN IP address and
DHCP server information, you can do it in “LAN” in “Advance”.
After the configuration is done, the ROUTER WAN-side interface is ipa_8_35.

If “Enable NAT” is disabled during the configuration, you must configure the route on
the BRAS; otherwise you cannot access your ISP. In applications, “Enable NAT” must
be checked.

4.5 Leased Line Mode

Descriptions
In this example, the ROUTER is connected to the DSLAM through PVC 8/35 and the
access mode is pure Bridging. The uplink interface of BRAS is encapsulated as 1483B,
the IP address is 10.28.108.1, the IP address of the uplink interface is 10.61.92.157. The
PC attached to the ROUTER is assigned a public IP address and the gateway is