Planet Technology ADE-3410v2 Manuale Utente
10.28.108.1.
Setting
Setting
1. Activate your browser and input “192.168.1.1” in the address column to login the
ROUTER.
2. Click “Advanced Setup” -> “WAN”, then click “add”.
3. In the “ATM PVC Configuration” interface configure VPI/VCI as 8/35 and then
click “Next”.
4. In the “Connection Type” interface, select “Bridging” and “LLC/SNAP-BRIDGING”
as the encapsulation, and then click “Next”.
5. In the “Unselect the check box below to disable this WAN service” interface, keep
the default configuration unchanged and then click “Next”.
6. Check the network configurations and make sure that all settings agree with the data
provided by your ISP, and then click “Save”.
7. Click “Save/Reboot” to apply the changes and reboot the system.
You can also modify the PVC 8/35. If you need to modify the LAN IP address, you can
do it in “LAN” of “Advance”.
Note: In the pure Bridging mode, there is no interface at the WAN side of the ROUTER.
4.6 PPP over Ethernet (PPPoE) IP Extension Mode
Descriptions
In this example, the ROUTER is connected to the DSLAM through “PVC 8/35”; the
PPPOE is located between the WAN interface of the ROUTER and BRAS. The
encapsulation of the downlink interface of BRAS is “PPP OVER ETHERNET”, the
authentication is AUTO, the IP address is 10.28.106.200, the IP Pool is 10.28.106.*, and
the IP address of the uplink interface is 10.61.92.157.
The WAN interface of the ROUTER obtains the IP address that is dynamically assigned
In this example, the ROUTER is connected to the DSLAM through “PVC 8/35”; the
PPPOE is located between the WAN interface of the ROUTER and BRAS. The
encapsulation of the downlink interface of BRAS is “PPP OVER ETHERNET”, the
authentication is AUTO, the IP address is 10.28.106.200, the IP Pool is 10.28.106.*, and
the IP address of the uplink interface is 10.61.92.157.
The WAN interface of the ROUTER obtains the IP address that is dynamically assigned
60