Rosewill RNWB-11001 Manuale Utente

By default, the radio button “All the PCs on the LAN are allowed to access the 

Router's Web-Based Utility” is checked. If you want to allow PCs with specific MAC 

Addresses to access the Setup page of the Router's Web-Based Utility locally from inside 

the network, check the radio button “Only the PCs listed can browse the built-in web 

pages to perform Administrator tasks”, and then enter each MAC Address in a 

separate field. The format for the MAC Address is XX-XX-XX-XX-XX-XX (X is any 

hexadecimal digit). Only the PCs with MAC address listed can use the password to 

browse the built-in web pages to perform Administrator tasks while all the others will be 

blocked.  

After click the Add button, your PC's MAC Address will be placed in the list above. 

Click the Save button to save your settings.   

)

If your PC is blocked but you want to access the Router again, use a pin to press and 

hold the Reset Button (hole) on the back panel for about 5 seconds to reset the Router’s 

factory defaults on the Router’s Web-Based Utility. 

 

Choose menu “Security → Remote Management”, you can configure the Remote 

Management function in the screen as shown in Figure 4-42. This feature allows you to 

manage your Router from a remote location via the Internet. 

 

Figure 4-42  Remote Management 

¾

 

Web Management Port - Web browser access normally uses the standard HTTP 

service port 80. This Router's default remote management web port number is 80. 

For greater security, you can change the remote management web port to a custom 

port by entering that number in the box provided. Choose a number between 1 and 

65534 but do not use the number of any common service port.   

-79-