Rosewill RNX-N150RT Manuale Utente

 

- 68 - 

¾

 

Web Management Port - Web browser access normally uses the standard HTTP service 

port 80. This Router's default remote management web port number is 80. For greater 

security, you can change the remote management web port to a custom port by entering that 

number in the box provided. Choose a number between 1 and 65534 but do not use the 

number of any common service port.   

¾

 

Remote Management IP Address - This is the current address you will use when accessing 

your Router from the Internet. This function is disabled when the IP address is set to the 

default value of 0.0.0.0. To enable this function change 0.0.0.0 to a valid IP address. If set to 

255.255.255.255, then all the hosts can access the Router from internet.   

)

1) 

To access the Router, you should type your Router's WAN IP address into your browser's 

address (in IE) or Location (in Navigator) box, followed by a colon and the custom port 

number. For example, if your Router's WAN address is 202.96.12.8, and the port number 

used is 8080, please enter 

 in your browser. Later, you may be asked 

for the Router's password. After successfully entering the username and password, you will 

be able to access the Router's web-based utility. 

2) 

Be sure to change the Router's default password to a very secure password. 

 

Figure 4-43 Access Control 

There are four submenus under the Access Control menu as shown in Figure 4-43: Rule, Host, 

Target and Schedule. Click any of them, and you will be able to configure the corresponding 

function. 

Please Note: The internet loading will be slow down when under “Access Control” due to all