Avaya X330W2-DS1 Manuale Utente

Chapter 7

X330WAN CLI Commands

122

Avaya X330W-2DS1 User’s Guide

If you cannot configure the hardware’s receive sensitivity, the receive 

sensitivity is fixed at 36 dB and is unaffected if you enter gain26 or gain36.

Example:
The following example changes the CLI receive sensitivity to match the actual 
receive sensitivity of the hardware and adds 15 dB of attenuation to the transmit 
signal:

X330WAN-2DS1-1(config-controller:1)# cablelength long 

gain36 -15db

Example:

no cablelength

Use the cablelength short command to configure transmit attenuation for a 
cable length (line build-out) of 655 feet or shorter for a T1 trunk with a DSX-1 
interface. Use the no form of this command to restore the default value.

This command can only be performed if the controller is set to T1.

The syntax for this command is:

 {133ft|266ft|399ft|533ft|655ft}

short

Configures parameters using the loop length.

133

Cable length of 0 to 133 feet. This is the default value.

266

Cable length of 134 to 266 feet.

399

Cable length of 267 to 399 feet.

533

Cable length of 400 to 533 feet.

655

Cable length of 534 to 655 feet.