Avaya X330W2-DS1 Manuale Utente
WAN CLI Commands
Avaya X330W-2DS1 User’s Guide
123
Note:
The transmit attenuation value is best obtained by experimentation. If the
signal received by the far-end equipment is too strong, reduce the transmit level by
entering additional attenuation.
entering additional attenuation.
Example:
The following example sets the transmit attenuation to the appropriate levels for a
cable between 134 and 266 feet long:
The following example sets the transmit attenuation to the appropriate levels for a
cable between 134 and 266 feet long:
X330WAN-2DS1-1(config-controller:1)# cablelength short 266ft
channel-group (Controller context)
Use the channel group command to create a channel-group (also referred to as
"ds0 bundle"). A channel group can be the underlying interface for a PPP session.
This command creates a logical interface, which is identified by a port number, a
colon, and a channel group number. For example, channel-group 8 on E1 port 2
would be referred to as "2:8" in all places where a channel-group is needed as a
parameter.
"ds0 bundle"). A channel group can be the underlying interface for a PPP session.
This command creates a logical interface, which is identified by a port number, a
colon, and a channel group number. For example, channel-group 8 on E1 port 2
would be referred to as "2:8" in all places where a channel-group is needed as a
parameter.
The syntax for this command is:
channel-group
channel-group
<channel-num> timeslots <timeslot-list
> speed {56
| 64}
Note:
The Speed option can be performed only when the controller is set to T1.
channel-num
ID number to identify the channel group. The valid
range is from 0 to 23 for T1 lines and from 0 to 30 for
E1 lines.
range is from 0 to 23 for T1 lines and from 0 to 30 for
E1 lines.
timeslot-list
Timeslots (DS0s) to include in this channel group.
The valid timeslots are:
• 1 to 24 for T1
• 1 to 31 for E1
Values can be either separated by a "," (to indicate a
list) or a "-" (to indicate a range)
The valid timeslots are:
• 1 to 24 for T1
• 1 to 31 for E1
Values can be either separated by a "," (to indicate a
list) or a "-" (to indicate a range)
speed
Acceptable values are 56 or 64.