Avaya X330WAN Manuale Utente
Chapter 6
X330WAN CLI Commands
120
Avaya X330WAN User’s Guide
description (Controller context)
Use the
description
command to set the description of the E1/T1 interface. This
description appears both in the
ifAlias
and the
circuitIdentifier
MIB values
for that interface. The
no
form of this command removes the controller’s
description.
Note:
This command can also be executed from the Serial, Loopback, Fast Ethernet,
and FabricFastEthernet interfaces.
Syntax
[no] description
<desc>
Parameters
Example
X330WAN-2DS1-1(config-controller:1)# description "E1 controller"
X330WAN-2DS1-1(config-controller:1)# no description
fdl
Use the
fdl
command to define an FDL type. FDL is used to define a remote
loopback for the module or to receive the far-end counters.
The no form of this command disables the FDL.
The no form of this command disables the FDL.
Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command only when ESF framing is defined.
1. This command can only be performed if the controller is set to T1.
2. Use this command only when ESF framing is defined.
Syntax
[no] fdl
<fdl-mode>
Parameters
Example
X330WAN-2DS1-1(configure)# fdl ansi
desc
A string describing the E1/T1 interface. The string may contain blanks
and can be up to 255 characters long.
and can be up to 255 characters long.
fdl-mode
ansi | att | both