Avaya X330WAN Manual Do Utilizador

Chapter 6

X330WAN CLI Commands

120

Avaya X330WAN User’s Guide

Use the

 description 

command to set the description of the E1/T1 interface. This 

description appears both in the 

ifAlias

 and the 

circuitIdentifier

 MIB values 

for that interface. The 

no

 form of this command removes the controller’s 

description.

This command can also be executed from the Serial, Loopback, Fast Ethernet, 

and FabricFastEthernet interfaces.

 <desc>

X330WAN-2DS1-1(config-controller:1)# description "E1 controller"

X330WAN-2DS1-1(config-controller:1)# no description

Use the

 fdl 

command to define an FDL type. FDL is used to define a remote 

loopback for the module or to receive the far-end counters.
The no form of this command disables the FDL.

Note:  
1.  This command can only be performed if the controller is set to T1.
2.  Use this command only when ESF framing is defined.

 <fdl-mode>

X330WAN-2DS1-1(configure)# fdl ansi

desc

A string describing the E1/T1 interface. The string may contain blanks 
and can be up to 255 characters long.

fdl-mode

ansi | att | both