Gefen EXT-HDKVM-LAN Manuale Utente

page | 18

In order a Sender and Receiver unit to communicate with one another, they must both be 

set to the same channel.  This is similar to changing the channel on a cable or satellite 

box in order to view a different program.  By default, all Sender and Receiver units are set to 

channel 0. 

 

 

 

 

 

 

1.  Access the Web interface by entering the IP address of the desired Sender or 

 if necessary.

2.  Click the 

Network tab.  The current channel is displayed within the Network Mode 

window group.

3.  Click the 

Channel Selection drop-down list and select the desired channel. 

Channel numbers can range from 0 to 255. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4.  Click the 

Save button on the right-hand side of Network Mode window group.

5.  The following message will be displayed, at the top of the page, indicating that the 

casting mode has been applied to the Sender or Receiver unit. 

 

 

6.  Access the Web interface of the next unit (Sender or Receiver) by entering its 

IP address.

7.  Repeat steps 2 - 5 for each Sender and Receiver to be changed.

Operating the HD KVM over IP

Basic Operation

NOTE:  When connecting Sender and Receiver units, it is highly 

recommend that the video channel for each unit is set to a channel 

other than 0.  This will allow for the addition of future Sender and/or 

Receiver units without causing video channel conflicts.