ZyXEL Communications P-335WT Manuale Utente
P-335 Series User’s Guide
63
Chapter 3 Connection Wizard
Figure 20 Connection Wizard: Wireless LAN
The following table describes the labels in this screen.
Table 12 Connection Wizard: Wireless LAN
LABEL
DESCRIPTION
Name(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the Prestige, make sure all wireless stations use the same
If you change this field on the Prestige, make sure all wireless stations use the same
SSID in order to access the network.
Channel
Selection
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Security
Select a Security level from the drop-down list box.
Choose Auto to use WPA-PSK security with a default Pre-Shared Key and only if your
Choose Auto to use WPA-PSK security with a default Pre-Shared Key and only if your
wireless clients support WPA-PSK. If you choose this option, skip directly to section
Choose None to have no wireless LAN security configured. If you do not enable any
wireless security on your Prestige, your network is accessible to any wireless
networking device that is within range. If you choose this option, skip directly to section
Choose Basic security if you want to configure WEP Encryption parameters. If you
choose this option, go directly to section
.
Choose Extend (WPA-PSK or WPA2-PSK) security to configure a Pre-Shared Key.
Choose this option only if your wireless clients support WPA-PSK or WPA2-PSK
respectively. If you choose this option, skip directly to section
.
Back
Click Back to display the previous screen.
Next
Click Next to proceed to the next screen.
Note: The wireless stations and Prestige must use the same SSID, channel ID and
WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is enabled) or
WPA2-PSK (if WPA2-PSK is enabled) for wireless communication.
WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is enabled) or
WPA2-PSK (if WPA2-PSK is enabled) for wireless communication.
3.3.1 Basic(WEP) Security
Choose Basic(WEP) to setup WEP Encryption parameters.