NEC IP8800/S2400 Manuale Utente
3.
Troubleshooting Functional Failures in Operation
122
4
notconnect
The BSU is not installed.
Check if as many BSU boards as required for active
BSU + standby BSU (if standby BSU is not required,
only active BSU) are installed. If installed, no action is
required. If not so, install the required number of BSU
boards.
BSU + standby BSU (if standby BSU is not required,
only active BSU) are installed. If installed, no action is
required. If not so, install the required number of BSU
boards.
5
initialize
The BSU is being initialized.
Wait until initialization completes.
6
disable
no power enable is set by
configuration command.
configuration command.
After checking that the BSU board to be used is
installed, use configuration command power
enable to make the BSU active, standby hot,
standby cold status, or standby cold status2.
installed, use configuration command power
enable to make the BSU active, standby hot,
standby cold status, or standby cold status2.
No.
BSU Operation
Status
Problem
Action