Peerless Industries PRS-1 Manuale Utente

ISSUED: 08-15-07  SHEET #: 055-9188-6   06-25-10 

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Place projector mount assembly (A) on ceiling as a template and mark the center of the two mounting holes. Make 
sure that the mounting holes are in the center of the wood joist. Drill two 5/32" (4 mm) dia. holes to a minimum depth 
of 2.5" (64 mm). Attach projector mount assembly (A) with two #14 x 2.5" (6 mm x 65 mm) wood screws (F) and two 
fl at washers (E) as shown in fi gure 2.1 or fi gure 2.2 depending on joist orientation. 

NOTE: Mounting slots on projector mount assembly allow for 30° (±15°) of rotation before fully securing wood 
screws.

Tighten wood screws (F) using 3/8" (10 mm) socket wrench or phillips screwdriver until projector mount assembly 
(A) is fi rmly attached.

WOOD JOIST

WOOD JOIST

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that projector mount assembly is fi rmly attached, but do not overtighten. Overtightening 

can damage the screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).

•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).