Peerless Industries PRS-1 Manuale Utente

ISSUED: 08-15-07  SHEET #: 055-9188-6   06-25-10 

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Place projector mount assembly (A) on ceiling as a 
template and mark the center of the two mounting 
holes. Drill two 1/4" (6 mm) dia. holes to a minimum 
depth of 2.5" (64 mm). Attach projector mount 
assembly (A) using two concrete anchors (G), two 
fl at washers (E), and two #14 x 2.5" wood screws 
(F) as shown. 

NOTE: Mounting slots on projector mount assembly 
allow for 30° (±15°) of rotation before fully securing 
wood screw.

Tighten wood screws (F) using 3/8" (10 mm) socket 
wrench or phillips screwdriver until projector mount 
assembly (A) is fi rmly attached. 

FRONT OF 
MOUNT

•  Tighten wood screws fi rmly, but do not overtighten. 

Overtightening can damage the screws, greatly re-
ducing their holding power.

•  Never tighten in excess of 80 in • lb (9 N.M.).

•  Always attach concrete anchors directly to load-

bearing concrete.

•  Never attach concrete anchors to concrete covered 

with plaster, drywall, or other fi nishing material. If 
mounting to concrete surfaces covered with a fi nish-
ing surface is unavoidable (not evaluated by UL), the 
fi nishing surface must be counterbored as shown be-
low. Be sure concrete anchors do not pull away from 
concrete when tightening screws. If plaster/drywall is 
thicker than 5/8", custom fasteners must be supplied 
by installer (not evaluated by UL).

concrete 
surface

Drill holes and insert anchors (G).

Place plate (A) over anchors (G) and secure with screws (F).

Tighten all fasteners.

plaster/

dry wall

concrete

concrete

plaster/

dry wall

•  Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-

ware and components.