Sanyo PLC-XU355K Manuale Utente

The preparation display will disappear

after 30 seconds.

(See page 55 for Lamp control status.)

Connect  the  projector’s AC  power  cord  into  an AC

outlet. The POWER indicator lights red. Open the lens

cap (see pages 8, 63).
Press  the  ON/SYAND-BY  button  on  the  top  control

or    on  the  remote  control.  The  POWER  indicator

lights green and the cooling fans start to operate. The

preparation  display  appears  on  the  screen  and  the

count down starts.

After the countdown, the input source that was selected

the last time and the lamp control status icon (see page

55) appear on the screen.

Complete  peripheral  connections  (with  a  computer,

VCR, etc.) before turning on the projector.

Note:
  The Filter warning and Lamp replacement icons

may appear on the screen depending on the

usage state of the projector.

Lamp control status

Note:
 • When the Logo select function is set to Off, the logo will

not be shown on the screen (p.49).

 • When Countdown off or Off is selected in the Display

function, the countdown will not be shown on the screen

(p.48).

 • During the countdown period, all operations are invalid.

 • When the Input Search function is set to On, the input

signal will be searched automatically (p.47).

•  When Off is selected in the Display function, the Video/

PC  selection  window  and  the  input  signal  guidance

window are not shown on the screen. (p.48)

If there is no signal input when start on the projector,

or the current signal is missed while operating the

projector, the Video/PC selection window will be

displayed on the screen, please move the pointer to

input source desired by pressing the Point ▲▼ buttons

and press the SELECT button. And then follow the

input signal guidance window to correct the signal and

connection.

If the projector is locked with a PIN code, PIN code input

dialog box will appear. Enter the PIN code as instructed

on the next page.

No signal

Current Input setting:Video

Is  signal  processed  correctly?
Is  cable  connected  properly?

No signal

Current Input setting:RGB

Is  signal  processed  correctly?
Is  cable  connected  properly?