Printronix T5000 Manuale Utente
Positioning The Media Sensors
39
Run A Barcode Demo Test
IMPORTANT
Printronix recommends using the supplied starter roll of 100
labels to setup and verify printer operation. This will avoid
expending the more expensive smart labels for this task.
labels to setup and verify printer operation. This will avoid
expending the more expensive smart labels for this task.
Before you send an actual print job, run a barcode demo test:
1.
Press the PAUSE key until “OFFLINE” displays.
2.
Press the TEST PRINT key until “Printer Tests/Barcode Demo”
displays.
displays.
3.
Press
↵. The Barcode Demo test pattern will start and print two
barcodes.
4.
Check the test pattern. If necessary, reposition the pressure
blocks to obtain a uniform print quality. In most cases, you will
need to adjust only the right pressure block.
blocks to obtain a uniform print quality. In most cases, you will
need to adjust only the right pressure block.
5.
If desired, you can run additional printer tests, such as Grey,
Grid, and Checkerboard. See step 1 above to start other tests.
Grid, and Checkerboard. See step 1 above to start other tests.
NOTE: These tests default to run continuously. Press
↵ to end the
test.