Zebra Technologies P640i Manuale Utente

58

P640i Card Printer User Guide

980541-001 Rev. A

6. Using a flat blade screwdriver turn the vertical 

offset adjust screw in ¼ turn increments

7. Re-install the cassette.  

 Once the front surface offset is consistently 
acceptable, inspect the back surface patches of the last 
few cards to pass through the laminator. Note the 
offset on the back surface. When flipping the cards for 
inspection, keep the mag stripe (if present) toward 
you.

Correct for vertical offset in the lower laminator using 
the same procedure as in upper cassette vertical 
offset adjustment. 

 > Printers (or Printers and Faxes) > Right click 

Zebra P640i > Properties > Device Settings > Control 
> Advanced Utilities > 

is also available by this route: 

Device Settings > Status >

. 

Temperatures measured by thermocouples in the top 
and bottom laminator heater cores. 

Reflective sensors that detect the presence of laminate 
on the transfer rollers. The threshold numbers are: 
Below 124 = laminate present 
Above 140 = laminate absent. 
The threshold numbers are not adjustable.  

Caution • Accurate positioning of the 
laminate sensors is essential! If they do 
not detect laminate reliably, 
performance of the entire printer is 
compromised.