Zebra Technologies 105SL Manuale Utente
80
105SL User Guide
6/4/2004 11342L Rev. 8
Troubleshooting
LED Error Messages
LED Error Messages
The LCD displays messages when there is an error. See
causes, and the recommended solutions.
Table 11 • LCD Error Messages
LCD
Possible Cause
Recommended Solution
Error Condition—
Ribbon Out
In Thermal Transfer Mode, the
ribbon is not loaded or loaded
incorrectly.
ribbon is not loaded or loaded
incorrectly.
Load the ribbon correctly. See
.
In Thermal Transfer Mode, the
ribbon sensor is not sensing
correctly loaded ribbon.
ribbon sensor is not sensing
correctly loaded ribbon.
).
In Direct Thermal Mode, when
ribbon is not used:
ribbon is not used:
Put the printer in Direct Thermal Mode via the front
panel and remove ribbon (if loaded).
panel and remove ribbon (if loaded).
Ensure that the printer driver or software settings
are correctly set (if applicable).
are correctly set (if applicable).
Error Condition—
Paper Out
The media is not loaded or
loaded incorrectly.
loaded incorrectly.
Reload the media. Refer to
.
The media sensor is not adjusted
properly.
properly.
Check the position of the upper and lower media
sensors. See
sensors. See
.
The printer is set for non-
continuous media, but
continuous media is loaded.
continuous media, but
continuous media is loaded.
Either load the correct media or set the printer for
the correct media type via the front panel.
the correct media type via the front panel.
Ensure that the printer driver or software settings
are correctly set (if applicable).
are correctly set (if applicable).
Calibrate the printer (see
).
The incorrect media sensor is
being used.
being used.
1.
2.
Calibrate the printer (see
).
The maximum label length is set
shorter than the label length
being used.
shorter than the label length
being used.
Via the front panel, set the label length to a value
that is slightly longer than the length of the label
being used.
that is slightly longer than the length of the label
being used.
Error Condition—
Head Open
The printhead is not fully closed. Close the printhead.
Warning—
Ribbon In
The ribbon is loaded.
Remove the ribbon and set the printer to Direct
Thermal Mode.
Thermal Mode.
Ensure that the printer driver and/or software
settings are correctly set (if applicable).
settings are correctly set (if applicable).