Zebra Technologies 105SL ユーザーズマニュアル

80

105SL User Guide

6/4/2004 11342L Rev. 8

LED Error Messages

The LCD displays messages when there is an error. See 

 for LCD errors, the possible 

causes, and the recommended solutions.

Error Condition—

Ribbon Out

In Thermal Transfer Mode, the 
ribbon is not loaded or loaded 
incorrectly.

Load the ribbon correctly. See 

. 

In Thermal Transfer Mode, the 
ribbon sensor is not sensing 
correctly loaded ribbon.

Perform the media and ribbon sensor calibration 
(see 

).

In Direct Thermal Mode, when 
ribbon is not used:

Put the printer in Direct Thermal Mode via the front 
panel and remove ribbon (if loaded).

Ensure that the printer driver or software settings 
are correctly set (if applicable).

Error Condition—

Paper Out

The media is not loaded or 
loaded incorrectly.

Reload the media. Refer to 

.

The media sensor is not adjusted 
properly.

Check the position of the upper and lower media 
sensors. See 

.

The printer is set for non-
continuous media, but 
continuous media is loaded.

Either load the correct media or set the printer for 
the correct media type via the front panel.

Ensure that the printer driver or software settings 
are correctly set (if applicable).

Calibrate the printer (see 

).

The incorrect media sensor is 
being used.

Via the front panel, check that the correct sensor 
is selected for the media loaded. See 

Calibrate the printer (see 

).

The maximum label length is set 
shorter than the label length 
being used.

Via the front panel, set the label length to a value 
that is slightly longer than the length of the label 
being used.

Error Condition—

Head Open

The printhead is not fully closed. Close the printhead.

Warning—

Ribbon In

The ribbon is loaded.

Remove the ribbon and set the printer to Direct 
Thermal Mode.

Ensure that the printer driver and/or software 
settings are correctly set (if applicable).