Zebra Technologies 7030 Manuale Utente

Specifications
Paper Specification

P1003636-002

TTP 7030™ Technical Manual

10/05/2009

See also 

Print side

Inner side (opposite to thermal coating side)

Sensor position

25 mm before cutter, and 9.1 mm from left edge of ticket 
entry when seen from the front of the printer (on the side of 
the blue release arm).

Mark length range

3 to 18 mm, default 5 mm

Mark width

Minimum 5 mm centered on the sensor position, 
recommended width is 9 mm

Print density

Standard wet offset mode is recommended for printing of the 
black-marks. The full mark area must be printed. Screen-
printing is not allowed. Measurement of print density must be 
performed relative to the white paper background. 

Using a MacBeth densitometer, the print density must be 
greater than 1.3. Anti-gloss filter is not allowed. Using a 
Gretag densitometer, the print density must be greater than 
1.5. The reflection from the black-mark must be less than 
10%. The reflection from the paper must exceed 80%.

Preprinting 

Preprinting in the zone passing over the black-mark sensor is 
not recommended. If required, OCR blind type of ink must be 
used, (outside the 700-1100 nm range).

Punched holes

Punching must be done from the thermally coated side. Distorted 
print can be expected within a zone of approximately 2-mm 
around the edges of the hole. The function must be tested.