DELL 530b Manuale Utente
Removing and Installing Parts
145
8 Connect the data cable to the system board.
9 Check all cables to be certain that they are properly connected and
9 Check all cables to be certain that they are properly connected and
firmly seated.
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
11 Connect your computer and devices to electrical outlets, and then turn
them on.
12 See the documentation that came with the drive for instructions on
installing any software required for drive operation.
13 Check the System Setup for drive configuration changes (see "Entering
Floppy Drive (Optional)
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTE:
If you are adding a floppy drive, see "Installing a Floppy Drive" on page 147.
Removing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 105.
2 Remove the computer cover (see "Removing the Computer Cover" on
2 Remove the computer cover (see "Removing the Computer Cover" on
book.book Page 145 Monday, October 6, 2008 11:28 AM