Blade ICE G8124-E Manuale Utente

BMD00220, October 2010

Chapter 26: Simple Network Management Protocol  

  365

To load a new switch image with the name “

MyNewImage-1.img

” into 

image2

, follow the 

steps below. This example shows an FTP/TFTP server at IPv4 address 192.168.10.10, though IPv6 
is also supported.

Set the FTP/TFTP server address where the switch image resides: 

Set agTransferServer.0 "192.168.10.10"

Set the area where the new image will be loaded: 

Set agTransferImage.0 "image2"

Set the name of the image:

Set agTransferImageFileName.0 "MyNewImage-1.img"

If you are using an FTP server, enter a username: 

Set agTransferUserName.0 "MyName"

If you are using an FTP server, enter a password: 

Set agTransferPassword.0 "MyPassword"

Initiate the transfer. To transfer a switch image, enter 2 (gtimg): 

Set agTransferAction.0 "2"

To load a saved switch configuration with the name “MyRunningConfig.cfg” into the switch, 
follow the steps below. This example shows a TFTP server at IPv4 address 192.168.10.10, though 
IPv6 is also supported. 

Set the FTP/TFTP server address where the switch Configuration File resides: 

Set agTransferServer.0 "192.168.10.10"

Set the name of the configuration file: 

Set agTransferCfgFileName.0 "MyRunningConfig.cfg"

If you are using an FTP server, enter a username: 

Set agTransferUserName.0 "MyName"

If you are using an FTP server, enter a password: 

Set agTransferPassword.0 "MyPassword"

Initiate the transfer. To restore a running configuration, enter 3: 

Set agTransferAction.0 "3"