Emerson ATCA-S201 Manuale Utente

RTM-ATCA-SXXX Overview 

6806800H62B 

ATCA‐S201 Installation and Use Guide 

 

43 

 

Table 21 CLI command syntax, set network property: Ethernet port configuration 

Convention: 

atca_blade set_network Y <portcode+> <enable> <dhcp> <ipaddr> <netmask> 
<broadcast> <gateway> <MAC> <MTU> + 

<portcode>   Use portcode 16+ to modify eth0 

Use portcode 24+ to modify eth1 
Use portcode 32+ to modify eth2 
Use portcode 40+ to modify eth3 
Use portcode 48+ to modify eth4 
Use portcode 52+ to modify VLAN 

<enable>  0|1   

Value 0 disables the port, value 1  enables the port. 

<dhcp>  0|1   

Value 0 disables dhcp, value 1  enables the dhcp.  When enabled, other network 
input fields are ignored. (ipaddr, netmask etc.) 

Remaining 

inputs 

ipaddr, netmask input formats etc. are defined in the sections below 

4.6.10  Enable (online/offline) 

  

<Read/Write> The user may set a port online or offline with this menu box.  When 

enabled the port in online, and will terminate IP traffic.  When the port is disabled, IP 

packets are not processed.    

4.6.11  DHCP 

  

<Read/Write> The user may configure any port for Dynamic Host Configuration 

Protocol (DHCP).  If DHCP is enabled, the port will search for a DHCP server to 
automatically set the IP address, subnet mask, default gateway address. 

4.6.12  IP address 

<Read/Write> The user may manually assign the IP address of a port, if DHCP is NOT 

enabled.   The address must be entered using dotted decimal notation. (e.g. 
192.168.1.211) 

4.6.13  Network (Subnet) mask 

<Read/Write> The user may manually assign the subnet mask of a port, if DHCP is 

NOT enabled.   The subnet mask must be entered using dotted decimal notation. 
(e.g. 255.255.255.0)