Emerson ATCA-S201 Manuale Utente

RTM-ATCA-SXXX Overview 

6806800H62B 

ATCA‐S201 Installation and Use Guide 

 

42 

 

Table 19 CLI command syntax, set network property: assign NTP server 

Convention: 

<server1>  

… <server5> 

Enter one to five NTP servers, specified as Dotted decimal or domain addresses 
(time.nist.gov) 

4.6.8  Network time protocol - NTP (On/Off) 

 

<Read/Write> Users may enable NTP protocol service to synchronize the ATCA-

S201’s clocks with a known good reference time source.   

4.6.9  Ethernet network port identification 

The ATCA-S201 provides multiple Ethernet interfaces that host blades may use to 
access storage.   Whether using the CLI or web based configuration tools, these 

ports are identified with the Linux resource labels shown in the table below 

Table 20 Ethernet ports for chassis communications (base/fabric) 

Linux interface identifier 

Port Description 

/dev/eth0 

10/100/1000 — Base 0 (Zone -2) 

/dev/eth1 

10/100/1000 — Base 1 (Zone -2) 

/dev/eth2 

10/100/1000 — Management (RTM, Rear I/O management 
port) 

/dev/eth3 

10G — Fabric 0 (Zone-2 XAUI ) 

/dev/eth4 

10G — Fabric 1 (Zone-2 XAUI ) 

The webtool provides a table for each Ethernet resource.  Users may enter new settings for any field, 

and click the submit button located at the top of the screen to apply the settings. 

Active Settings

192.168.200.32

255.255.255.0

192.168.200.255

192.168.200.1

1500

00:11:0D:xx:xx:xx

New Settings

DHCP

Enable

dhcp

1500

0.0.0.0

0.0.0.0

0.0.0.0



