Xantrex Technology XDL 35-5TP Manuale Utente

  

20 

Alarm output 'open' for main Output off, 'closed' for main Output on 

21 

Alarm output 'closed' when Aux Output is in Current Limit.   
Set with control assigned to Output 1; applies to Output 1 alarm only. 

22 

Alarm output 'closed' when over-temperature trip occurs 

23 

Alarm output 'closed' when sense trip occurs 

24 

Alarm output 'closed' when over-current trip occurs 

25 

Alarm output 'closed' when over-voltage trip occurs 

26 

Alarm output 'closed' when any trip occurs (factory default) 

30 Buzzer 

off 

31 

Buzzer on (factory default).  A single beep indicates confirmation, a double beep 
indicates a wrong entry. 

40 

Jog digit flashes, JOG indicator  only flashes when jog is 'hidden' 

41 

JOG indicator always flashes, except when 'hidden' (factory default) 

42 

JOG indicator doesn't flash, except when 'hidden' (lazy flash) 

91 

Loads default calibration parameters.  Refer to Service Manual 

92 

Shows firmware version number in the display 

93 

Sets these # settings to their factory default 

99 

Enter calibration mode.  Refer to Service Manual. 

The ex-factory default settings (which will apply at first power-up) are as follows: 

Range: 35V/3A 
Voltage: 1·000V 
Current Limit:  1·000A 
OVP: 40V 
OCP: 5·5A 
Output: 

Output off; local Sense 

# Settings: 

00 

Main Output always off at power-up 

 

02 

Aux Output always off at power up (an Output 1 # function only). 

 

26 

Alarm output 'closed' when any trip condition occurs 

 31 

Buzzer 

on 

 

41 

JOG indicator always flashes; 'lazy' flash when hidden 

RS232: 

9,600 Baud (XDL 35-5TP only) 

Address: 

11 (XDL 35-5TP only) 

The following hardware errors are indicated by showing the appropriate error number in the display.  
The OK key will flash and if pressed the error will be ignored and operation will continue as described. 

1 

Calibration constants corrupted at power-up  Loads default calibration parameters 

2 

# functions corrupted at power-up 

Loads default # settings 

3 

Power-down settings not correctly loaded at 
power up 

Loads factory default power-up 
settings 

Switching the instrument off with the error message showing will leave all settings unchanged. 

  

 

23