NEC VE282 Manuale Utente

This section helps you resolve problems you may encounter while setting up or using the projector.

Off

The power cord is unplugged�

–

Blinking light

Green 0�5 sec On,

0�5 sec Off

The projector is getting ready to turn on�

Wait for a moment�

Steady light

Green

The projector is turned on�

–

Orange

[NETWORK STANDBY] is selected for [STANDBY 

MODE]

–

Red

[NORMAL] is selected for [STANDBY MODE]

–

Off

Normal or Standby ([NORMAL] for [STANDBY 

MODE])

–

Blinking light

Red

2 cycle (0�5 sec 

On, 0�5 sec Off)

Temperature error

The projector is overheated� Move the projector to 

a cooler location�

4 cycle (0�5 sec 

On, 0�5 sec Off)

Fan error

Fans will not work correctly�

6 cycle (0�5 sec 

On, 0�5 sec Off)

Lamp error

Lamp fails to light� Wait a full minute and then 

turn on again�

Green

Re-firing the lamp (The projector is cooling 

down�)

The projector is re-firing.

Wait for a moment�

Steady light

Green

Standby ([NETWORK STANDBY] for [STANDBY 

MODE])

–

Orange

Cabinet button is locked

You have pressed cabinet button when Cabinet 

Button is locked�

Off

Normal

–

Blinking light

Red

Lamp has reached its end of life� Lamp 

replacement message will be displayed�

Replace the lamp�

Steady light

Green

[ECO MODE] is set to [ON]

–

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the 
lamp with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:

•  Unplug the power cord after the cooling fans stop.

•  Move the projector to a cooler location if the room where you are presenting is particularly too warm.

•  Clean the ventilation holes if they are clogged with dust.

•  Wait about 60 minutes until the inside of the projector becomes cool enough.