ADC MM701G Manuale Utente

The WAN configuration sets up from 1 to 32 sessions between the modem and the service 
provider or between two G.shdsl modems (see Chapter 7, “Implementing a Point-to-Point LAN 
Extension” for more information). Each session can be configured separately, specifying the 
protocol, IP address, ATM connection identifier, ATM QoS, and more.

The following should be supplied by the service provider before configuring WAN sessions:

❑

Protocol for each session, where the choices are the following for a maximum of 32:

RFC 1483-Bridge (up to 8 sessions)

RFC 1483-Router (up to 16 sessions)

PPPoA or PPPoE (up to 8 sessions for either type)

❑

IP address and subnet mask for each session using RFC 1483-Router protocol.

❑

RIP version (each direction) for each session using RFC 1483-Router protocol or PPP:

RIP Version1

RIP Version 2

RIP Version 1 and RIP Version 2

❑

Encapsulation for 1483-Bridge or 1483-Router, where the choices are:

LLC

VCMux

❑

Login and authentication for each session using PPP protocol, where the choices are:

login name and password

authentication type of either PAP or CHAP

❑

ATM parameters for each session, including:

VPI and VCI values

Quality of Service (QoS) which could be UBR, CBR, or VBR-nrt, and VBR-rt, and 
applicable cell rates