ADC MM701G 사용자 설명서
MM701G and MM702G User Manual
25
4
C
ONFIGURING
THE
WAN
The WAN configuration sets up from 1 to 32 sessions between the modem and the service
provider or between two G.shdsl modems (see Chapter 7, “Implementing a Point-to-Point LAN
Extension” for more information). Each session can be configured separately, specifying the
protocol, IP address, ATM connection identifier, ATM QoS, and more.
provider or between two G.shdsl modems (see Chapter 7, “Implementing a Point-to-Point LAN
Extension” for more information). Each session can be configured separately, specifying the
protocol, IP address, ATM connection identifier, ATM QoS, and more.
B
EFORE
Y
OU
B
EGIN
. . .
The following should be supplied by the service provider before configuring WAN sessions:
❑
Protocol for each session, where the choices are the following for a maximum of 32:
•
RFC 1483-Bridge (up to 8 sessions)
•
RFC 1483-Router (up to 16 sessions)
•
PPPoA or PPPoE (up to 8 sessions for either type)
❑
IP address and subnet mask for each session using RFC 1483-Router protocol.
❑
RIP version (each direction) for each session using RFC 1483-Router protocol or PPP:
•
RIP Version1
•
RIP Version 2
•
RIP Version 1 and RIP Version 2
❑
Encapsulation for 1483-Bridge or 1483-Router, where the choices are:
•
LLC
•
VCMux
❑
Login and authentication for each session using PPP protocol, where the choices are:
•
login name and password
•
authentication type of either PAP or CHAP
❑
ATM parameters for each session, including:
•
VPI and VCI values
•
Quality of Service (QoS) which could be UBR, CBR, or VBR-nrt, and VBR-rt, and
applicable cell rates
applicable cell rates