ADC SWD4573I1 Manuale Utente

You can configure bridging and routing sessions using PVCs that terminate on the management 
card (for example, PVCs between ADSL cards and the management card or PVCs between OC3 
line cards and the management card). You can configure 96 bridging and routing sessions. 

To configure a bridging or routing session, you configure a PVC between a line or channel card 
and the management card, then set up the desired service for the session (bridging, routing or 
both). The system automatically assigns the management card VPI and VCI for each session. If 
you are configuring a session using a frame-based card, the system automatically assigns the 
VPI and VCI and configures the session to use VC-MUX_Bridged encapsulation mode.

You configure sessions using the command-line interface from the 

::session=>

 prompt. 

From the 

::root=>

 prompt, type the following command then press 

 to display the 

::session=>

 prompt.

From the 

::session=>

 prompt, type the new command in the following format then press 

. 

new <slot.port> <vpi|*> <vci|*> <(llc-snap|vcmuxbr|vcmuxrt)>

[-dlci <dlci>] [-subs <subscriber>] [-service

(bridge|{{route|broute} -ipaddr <ipaddr> -mask <ipmask>})]

[-stppri <priority>] [-stpcost <cost>][-admin (up|down)]

<slot.port>

The line or channel card slot and port you want to use for this PVC.

<vpi|*>

The VPI you want to use for this PVC. Type * if you are using an SDSL channel card for 
the PVC, as the system automatically assigns the VPI in this case. 

<vci|*>

The VCI you want to use for this PVC. Type * if you are using an SDSL channel card for 
the PVC, as the system automatically assigns the VCI in this case.